Forerunner 610 [nový firmware]

[Path]

Forerunner 610 software version 2.20 (4.5.2011) [RGN, Mirror]

Aktualizace pouze přes WebUpdater

Changes made from version 2.10 to 2.20:

* Fixed an issue where old activities were not deleted correctly prior to the unit running out of memory.
* Fixed an issue where GPS would turn back on after the timer was started, even if the user had previously turned it off.
* Fixed an issue where a new activity from a previous day would not be transferred to the computer until the watch was taken out of power save mode.
* Fixed an issue where auto scroll would not work while the unit was in cycling mode.
* Fixed an issue where custom alerts would not work correctly after exiting power save mode.
* Added a beep when the unit gets a GPS fix while displaying the locating satellites banner.

[Path]

Forerunner 610 software version 2.40 (30.6.2011) [RGN, Mirror]

Changes made from version 2.30 to 2.40:

* Fixed issue introduced in previous revision where workouts sent from Garmin Training Center could not be used on the device.
* Fixed issue where all saved locations were deleted when upgrading firmware on the device.

Changes made from version 2.20 to 2.30:

* Fixed an issue with GPS accuracy decreasing for a short period of time when the timer was started or lapped.
* Improved transfers to Garmin ANT Agent.
* Added a progress bar for files currently being transferred to Garmin ANT Agent.
* Fixed screen pixilation issue seen on some devices while in power save mode.
* Fixed an issue with the average lap timer data field not populating correctly.
* Fixed an issue with the workout banner not always appearing on the screen to display the next step.
* Fixed an issue with activities created while using a custom workout with a high alert not uploading to Garmin Connect.
* Fixed an issue with Virtual Races created from indoor activities.
* Fixed an issue where the foot pod would not provide distance correctly if the GPS signal dropped out.
* Improved elevation smoothing algorithm.
* Improved auto pause filtering.

[Path]

Forerunner 610 software version 2.60 (21.9.2011) [RGN, Mirror]

Changes made from version 2.40 to 2.60:

* Added a heart rate recovery message that is displayed two minutes after the timer is stopped.
* Added a setting to allow the removal of the clock page from the training page loop while the timer is running (see Setup->Training Pages->Clock Page).
* Fixed an issue where the device could incorrectly connect to another user's HR monitor, foot pod, or bike sensor.
* Made a change to prevent Training Effect from being reset to zero for two-part activities that are continued after the watch goes to power save mode or is shut down.
* Fixed some instances that could cause the device to report that zero calories were burned during an activity.
* Fixed an issue with the calculation of the time value displayed in the Avg. Lap data field.
* Changed the calculation for the Time Behind data field on the Virtual Partner page to result in a smoother value.
* Made improvements to the Virtual Partner alert to try to prevent frequent alerts when running very close to the target pace.
* Fixed an issue where scaling the Virtual Racer's pace/speed was not working correctly.
* Fixed a workout issue where a repeat until time/distance step at the end could cause a loss of time/distance in the saved activity.
* Fixed an issue where an activity could be corrupted if the battery died in the middle of it.
* Fixed some weight scale issues that could cause the body fat % reported by the scale to be incorrect.
* Fixed an issue where the default locations stored on the device could be inadvertently deleted.
* Added full support for the Russian language.
* Fixed some translation issues.